Installation and preparation of bathroom stone countertops

Installation work:

 

　　 1. Remove the countertop door before installation to avoid damage.

 

　　 2. Put the cupboard in carefully. Check to see if the edge of the countertop is level.

 

　　3. If it is not level, you can put a wooden gasket under the table to ensure the level. Check to see if it is vertical.

 

　　 4. Once the table top is level, fix it with nails.

 

　　 5. Recheck whether the table top is level.

 

　　 6. Use a chisel and hammer to cut off the excess gasket. Be careful not to damage your floor.

 

　　 7. Depending on the height of the gasket, the bottom of the cabinet sometimes needs to be cast. Fasten with nails.

 

　　 8. Fasten the countertop door again.

 

　　 9. Spray latex along the top edge of the countertop.

 

　　 10. Place the countertop on the top of the countertop, squeeze the countertop, and let the latex dry completely.

 

　　 11. Install sinks and other equipment.

 

  Ready to work:

 

　　 Preparation work is very important for any project, and the installation of bathroom countertops is the same. Wear goggles when using power tools.

 

　　Measure the size of the installation space before purchasing.

 

　　Measure the height and width of the table.

 

　　Measure and mark the height of the countertop to the floor from three different places. Using the tallest mark, draw the width of the countertop on the wall. Draw the table on the left and right sides of the wall. Make sure these lines are vertical and horizontal. Now you can have the preliminary outline of the countertop. Tack at least one tack in the contour area.

 

　　 Measure the position of the water pipe and mark it on the back of the table.

 

　　 Dug a pipe hole behind the countertop. Make sure that each water pipe has enough space.